HOW TO INSTALL OUR 3D WALL PANELS


You just have read our article about our new 3D Wall Panels and you fell in love with it ? Then, this article is for you ! We are going to explain you how to install it step by step…

Here are some recommendations before you get started:

Our Decoflair® Wall Panels must be stored dry and flat. The recommended temperature is +15°C to +25°C. For best results, storage and installation will be in conditions of humidity and temperatures close to those found in the rooms after mounting. Laying on wet support as well as very high temperatures, is excluded.

Wipe the edges and the back surface of the panels with a slightly damp sponge to wall dust off and allow to dry. Ensure also that the support is clean, free of dust and grease.

Our Decoflair® Wall Panels are only intended for indoor use.

 

Installation with visible joints

How to install our 3D Wall Panels

 

 

1. Paint the panels using a roller for smooth surfaces or spray. Be sure also to apply a coat of paint on the edges of the panels.
TIP: The Decoflair® Wall Panels are compatible with any type of paint. However, it is recommended to perform a test coat…

Step 1 | How to install our 3D wall panels

 

 

2. With the help of a panel draw up reference marks to determine the final alignment of the panels

 

 

3. During the drying time drive support nails at the bottom line for stabilization in case of free-standing installation

 

 

4. Pay attention to matching the colour of the bottom seal and the final colour of the panels.

 

 

5. Glue on a regular basis the back of the panels with Decoflair® PLUS adhesive taking care to provide the whole perimeter with a continuous glue line.

Tip: Adhesive consumption: +/-1 cartridge adhesive for 4 Decoflair® Wall Panels

Step 5 | How to install our 3D wall panels

Step 5 | How to install our 3D wall panels

 

 

6. Align the panels and press them firmly until the glue adheres,  according to the adhesive manufacturer’s recommendations.

Step 6 | How to install our 3D wall panels

Step 6 | How to install our 3D wall panels

 

 

7. In order to achieve an installation with uniform joints, use between each panel tile crosses of 2 mm.

TIP: make sure that the joints between the panels are free of glue.

Step 7 | How to install our 3D wall panels

 

 

 

Installation without visible joints

How to install our 3D wall panels

 

 

1. With the help of a panel draw up reference marks to determine the final alignment of the panels.

 

 

2. During the drying time drive support nails at the bottom line for stabilization in case of free-standing installation.

 

 

3. Glue on a regular basis the back of the panels with a polymer assembly adhesive taking care to to provide the whole perimeter with a continuous glue line.

TIP: Adhesive consumption: +/-1 cartridge adhesive for 4 Decoflair® Wall Panels

 

 

4. Align the panels and press them firmly until the glue adheres,  according to the adhesive manufacturer’s recommendations

Step 4 | How to install our 3D wall panels

 

 

5. Use an acrylic sealant or an adhesive filler and evenly smooth it to fill the joints between the panels.

 

 

6. Paint the panels using a roller for smooth surfaces or spray.

TIP: The Decoflair ® Wall Panels are compatible with any type of paint. However, it is recommended to perform a test coat.


Leave a comment

Your email address will not be published.

4 thoughts on “HOW TO INSTALL OUR 3D WALL PANELS